Available online at www.sciencedirect.com ScienceDirect Materials Today: Proceedings 5 (2018) 23733–23742 www.materialstoday.com/proceedings 2214-7853© 2018 Elsevier Ltd. All rights reserved. Selection and/or Peer-review under responsibility of International Conference on Advances in Materials and Manufacturing Applications [IConAMMA 2017]. IConAMMA_2017 Strength properties of concrete blocks with Sand Manufacture Sludge as partial replacement to fine aggregate Febin G Kottukappalli a , R Ramkrishnan a *, Dhanya Sathyan a , K M Mini a a Department of Civil Engineering, Amrita School of Engineering, Coimbatore, Amrita Vishwa Vidyapeetham, Amrita University, India Abstract The proper disposal of Sand Manufacture Sludge(SMS) from the site is a major problem faced by most of the stone crushing units. SMS when dried is in the form of a fine powder. Due to its sticky nature and time taken to dry, transporting this material is very tedious. Hence it necessitates for finding a solution for the usage at the site itself, in the form of a construction material. This study focuses on replacing M Sand with SMS for the development of concrete building blocks. The study evaluates the effectiveness of use of this waste SMS in manufacturing concrete building blocks and estimating its strength properties, keeping a constant workability throughout. The strength, impact and abrasion properties of the concrete blocks are studied and compared with the conventional blocks and shows good agreement. © 2018 Elsevier Ltd. All rights reserved. Selection and/or Peer-review under responsibility of International Conference on Advances in Materials and Manufacturing Applications [IConAMMA 2017]. Keywords: SMS, Concrete, Compressive strength, Split Tensile strength, Impact strength, Abrasion resistance, building block. ____________________________________________________________________________________________ * Corresponding author. Tel.: +919940331223 E-mail address: r_ramkrishnan@cb.amrita.edu