10.22376/ijlpr.2023.13.5.L302-L310 ijlpr 2023; doi Revised On 6 July, 2023 Accepted On 20 July, 2023 Published On 1 September, 2023 Funding This research was funded by the National Agency of Scientific Research and Innovation, Albania (NASRI), Board of Administration Decision N0. 1, Date 05.07.2022. Copyright @ International Journal of Life Science and Pharma Research, available at www.ijlpr.com Int J Life Sci Pharma Res., Volume13., No 5 (September) 2023, pp L302-L310 This article is under the CC BY- NC-ND Licence (https://creativecommons.org/licenses/by-nc-nd/4.0) Citation Prof. Edit Xhajanka, Dr. Neada Hysenaj, Prof. Dr. Vergjini Mulo, Dr. Dorina Mele, Dr. Tedi Verçani, and Dr. Endrit Paparisto , The Evaluation and Comparison of Removable Dentures Constructed with The SR-IVOCAP System and The Traditional System..(2023).Int. J. Life Sci. Pharma Res.13(5), L302-L310 http://dx.doi.org/10.22376/ijlpr.2023.13.5.L302-L310 Received On 29 May, 2023 Dr. Neada Hysenaj , University Dental Clinic, Tirana, Albania. *Corresponding Author Research Article International Journal of Life science and Pharma Research The Evaluation and Comparison of Removable Dentures Constructed with The SR-IVOCAP System and The Traditional System. Prof. Edit Xhajanka 1 , Dr. Neada Hysenaj 1,2 , Prof. Dr. Vergjini Mulo 1 , Dr. Dorina Mele 3 , Dr. Tedi Verçani 2 , and Dr. Endrit Paparisto 4 1 Faculty of Dental Medicine, University of Medicine, Tirana, Albania. 2 University Dental Clinic, Tirana, Albania. 3 IVODENT Academy, University in Tirana, Albania 4 Private Dental Clinic Abstract: The treatment of edentulous patients is still a challenging problem. Acrylic resin is the most used material for constructing removable denture bases. The main disadvantage of this material is resin shrinkage, which occurs during and after polymerization. Our study aimed to evaluate the denture parameters regarding patient satisfaction regarding the removable dentures constructed with two different processing techniques: compression molding and injection. 80 patients, who came in the University Dental Clinic, Tirana were examined and evaluated. Those who fulfilled the criteria were treated with removable dentures. The patients were divided into two groups: in the first group, 40 patients were treated with removable dentures constructed with the compression molding technique, and in the second group, 40 patients were treated with removable dentures constructed with the injection molding technique. All the clinical and laboratory procedures until the processing technique were identical. After denture delivery, all the patients were re-scheduled to fulfill a questionnaire regarding four parameters of the removable dentures: denture stability, mastication efficiency, denture comfort, and quality of dentures in general. Results. The descriptive statistics of the data were done. Sample t-test showed that the SR IVOCAP dentures had higher mean values for all the parameters than the traditional dentures. Based on our study, the satisfaction of the patients treated with removable dentures with the SR-IVOCAP system for all the parameters evaluated was higher compared to the patient satisfaction treated with traditional removable dentures. Keywords: SR IVOCAP Dentures, Compression, Molding, Injection, Patient Satisfaction. ISSN 2250-0480