Dasar-Dasar Teknik Kimia ISSN 1410-9891 Peningkatan Daya Saing Nasional Melalui Pemanfaatan Sumber Daya Alam untuk Pengembangan Produk dan Energi Alternatif 1 PERBANDINGAN PRALAKUAN KOAGULASI DENGAN MENGGUNAKAN FeSO 4 .7H 2 O & Al 2 (SO 4 ) 3 .18H 2 O TERHADAP KINERJA MEMBRAN MIKROFILTRASI POLYPROPILENE HOLLOW FIBER Eva Fathul Karamah dan Fedy Gusti Kostiano Program Studi Teknik Kimia, Departemen Teknik Gas & Petrokimia Fakultas Teknik Universitas Indonesia, Depok 16424, Indonesia Abstrak Proses pengolahan air dengan menggunakan membran mikrofiltrasi sangat rentan terhadap fouling, sehingga air umpan yang akan memasuki proses harus diberi pralakuan, berupa koagulasi. Penelitian ini bertujuan untuk mempelajari dan membandingkan sejauh mana pengaruh proses pralakuan koagulasi dengan menggunakan dua koagulan yang berbeda terhadap kinerja membran mikrofiltrasi polypropylene hollow fiber, yaitu peningkatan fluks permeat dan % removal (dilihat dari TDS dan COD-nya), sekaligus memilih koagulan yang tepat untuk proses ini. Dalam penelitian ini, koagulan yang digunakan ialah koagulan berbasis aluminium, yaitu Al 2 (SO 4 ) 3 .18H 2 O, dan koagulan berbasis ferrum/besi, yaitu FeSO 4 .7H 2 O, dengan variasi dosis tertentu. Dari hasil penelitian didapatkan bahwa untuk koagulan FeSO 4 .7H 2 O, dengan dosis 70 ppm, persentase keefektifan koagulasi dapat mencapai 68% untuk penyisihan (removal) TDS dan 41 % untuk penyisihan COD-nya. Fluks permeat yang diperoleh sebesar 0,008 m 3 /m 2 /jam. Persentase penyisihan TDS dan COD dalam proses mikrofiltrasinya ialah 57% dan 43%. Sedangkan untuk koagulan Al 2 (SO 4 ) 3 .18H 2 O, dengan dosis 70 ppm, persentase keefektifan koagulasi mencapai 55% untuk penyisihan TDS dan 39% untuk penyisihan COD. Fluks permeat yang diperoleh sebesar 0,02 m 3 /m 2 /jam. Persentase penyisihan TDS dan COD dalam proses mikrofiltrasinya ialah 40% dan 39 %. Untuk penggunaan koagulan FeSO 4 .7H 2 O, disarankan pH air umpan berkisar 8 – 9, dengan kecepatan pengadukan 120 rpm (selama 2 menit), dan 40 rpm (selama 10 menit), waktu pengendapan ± 1 jam. Sedangkan untuk koagulan Al 2 (SO 4 ) 3 .18H 2 O, pH umpan berkisar 5,5-6,5, dan kecepatan pengadukan sama dengan koagulan FeSO 4 .7H 2 O, namun waktu pengendapan cukup ± 30 menit. Kata kunci: mikrofiltrasi, pengolahan air, koagulasi, aluminium sulfat, ferrous sulfat Abstract Microfiltration membrane in the water treatment process is susceptible to fouling. So, the feed water that enter this process must be pretreated, such as coagulation. The aim of this research are to study and compare the effect of coagulation process by using two different coagulants based on the performance of polypropilene hollow fiber microfiltration membranes, which are the increase of permeate flux and removal percentage of TDS and CO; and to choose the suitable coagulant for this process. In this research, the coagulants used are aluminium based coagulant (Al 2 (SO 4 ) 3 .18H 2 O) and ferrum based coagulant (FeSO 4 .7H 2 O), which is varied in certain dosages. The result for FeSO 4 .7H 2 O coagulant with 70 ppm dosage are, the percentage of coagulant effectivity increase to 68% for the TDS removal, and 41% for COD removal. The permeate flux is 0,008 m 3 /m 2 /jam, TDS and COD removal percentage are 57% and 43%. While for Al 2 (SO 4 ) 3 .18H 2 O coagulant with the same dosage (70 ppm), the percentage of coagulant effectivity is 55% for TDS removal and 39% for COD. The permeate flux is 0,02 m 3 /m 2 /jam, and TDS and COD removal are 40% and 39%. For the used of FeSO 4 .7H 2 O coagulant, it is suggested that feed water pH in the range of 8-9, with mixing speed 120 rpm (2 minutes), 40 rpm (10 minutes), and continued with 1 hour of settling time. For Al 2 (SO 4 ) 3 .18H 2 O coagulant, the feed water pH is 5,5-6,5, and mixed with the same speed as FeSO 4 .7H 2 O coagulant, but the settling time is only 30 minutes average. Key word: microfiltration, water treatment, coagulation, aluminium sulphate, ferrous sulphate