JETri, Volume 11, Nomor 1, Agustus 2013, Halaman 1 -16, ISSN 1412-0372 PERANCANGAN SISTEM OTOMASI TEKANAN UAP, SUHU, DAN LEVEL AIR PADA DESTILASI AIR DAN UAP DENGAN DAYA 2200 WATT MENGGUNAKAN MIKROKONTROLER Fachnur Firdaus I.T, Syamsir Abduh Universitas Trisakti Jl. Kyai Tapa No.1, RT.6/RW.16, Grogol, Grogol petamburan, Daerah Khusus Ibukota Jakarta, Indonesia E-mail: fahnur.firdaus@gmail.com, syamsir@trisakti.ac.id ABSTRAK Telah dirancang sebuah sistem otomasi pengatur tekanan uap, suhu, dan level air menggunakan Mikrokontroler Arduino Mega 2560 dengan sensor tekanan MPX5500D, sensor suhu termokopel tipe-K, sensor level air dengan memanfaatkan kondisi transistor saat cut off dan saturasi. Tujuan dirancangnya sistem otomai ini adalah untuk mengatur parameter kerja mesin destilasi air dan uap berupa tekanan uap 2.02 bar, suhu 80 °C – 100 °C, dan level air didalam tangki. Sensor MPX5500D akan mengukur tekanan udara 0 – 2 bar yang menghasilkan tegangan keluaran 0.2 volt DC – 2.11 volt DC. Sensor termokopel tipe-K akan mengukur suhu 80 °C – 100 °C yang menghasilkan tegangan keluaran 0 – 5 mV. Kondisi transistor saat cut off dan saturasi dimanfaatkan sebagai sensor level air untuk mendeteksi level air yang menghasilkan tegangan digital 0 volt dan 5 volt. Tegangan keluaran analog dan digital dari sensor akan diubah menjadi sinyal masukan pada mikrokontroler. Sinyal akan diproses menjadi perintah berdasarkan program yang dibuat berupa open/close relay sehingga solenoid valve dan heater akan ON/OFF. Kata kunci: Destilasi air dan uap MPX5500D, sensor termokopel tipe-K, Transistor NPN, Arduino Mega 2560 ABSTRACT Has designed an automation system regulating steam pressure, temperature, and water levels using Arduino Mega 2560 Microcontroller with MPX5500D pressure sensor, thermocouple type-K sensor, water level sensor by utilizing the transistor condition when the cut-off and saturation. The purpose of this automation system designed was to set the working parameters of water and steam distillation machine in the form of steam pressure 2.02 bar, temperature of 80 ° C - 100 ° C, and the water level in the tank. MPX5500D sensor will measure the air pressure of 0-2 bar which generates output voltage 0.2 volt DC - 2:11 volt DC. Type-K thermocouple sensor will measure the temperature of 80 ° C - 100 ° C which produces a voltage output 0-5 mV. Transistor condition when the cut-off and saturation used as water level sensors to detect water level which produces digital voltage of 0 volt and 5 volt. Analog and digital output voltage of the sensor is converted into a