BRAZIL AUTOMATION ISA 2013 XVII Congresso Internacional e Exposição Sul-Americana de Automação, Sistemas e Instrumentação PROTETOR ATIVO AURICULAR INDUSTRIAL Ivando Severino Diniz ivando@sorocaba.unesp.br Grupo de Automação e Sistemas Integráveis (GASI) UNESP - Universidade Estadual Paulista – Campus de Sorocaba Eduardo Paciência Godoy epgodoy@sorocaba.unesp.br Grupo de Automação e Sistemas Integráveis (GASI) UNESP - Universidade Estadual Paulista – Campus de Sorocaba Diego Colón dcolon@sorocaba.unesp.br Grupo de Automação e Sistemas Integráveis (GASI) UNESP - Universidade Estadual Paulista – Campus de Sorocaba Wesley Angelino de Souza wesley@dei.unipd.it Grupo de Automação e Sistemas Integráveis (GASI) UNESP - Universidade Estadual Paulista – Campus de Sorocaba Luiz Carlos S. Góes goes@ita.br Instituto Tecnológico de Aeronáutica – CTA / ITA São José dos Campos - SP Abstract This work presents a prototype of an active ear protection system using adaptive filter techniques. The system is composed of a traditional passive ear protection device, a set of microphones for measuring the environmental noise, and an adaptive filter implemented in a digital signal processor (DSP). In the modern world, the human being is constantly exposed to annoying and frequently dangerous noises that can lower the performance at workplaces, and even cause harm to the ears (not to mention psychological problems). The active ear protection device presented in this paper was constructed using two microphones (one for measuring the noise level at the outer part of the system and the other for measuring the residual noise after the cancelation). The adaptive filter used was a FIR (finite impulse response) with the LMS (least mean square) parameter varying mechanism. This is a closed-loop system with the speaker as the actuator (that generates the sound wave for cancelling the noise in the internal part, near the ear). The system plant is then the speaker, the ear and the air between them. The error signal is the noise in the internal part (measured by a microphone). The controller is the adaptive filter, and the ADSP-BF533 was used for the implementation, and the code was developed in the VisualDSP++ 5.0.Tests were conducted with different frequencies in order to evaluate the overall system performance Key words: Active Ear Protection, Active Vibration Control, Adaptive Filter. Resumo Este trabalho apresenta o protótipo de um protetor ativo auricular utilizando técnica de filtro adaptativo. O sistema é constituído de um protetor auricular passivo e microfones em conjunto com um filtro adaptativo digital. Atualmente, é muito comum a situação em que um ser humano é exposto a ruídos constantes originados por motores de carros, ar condicionado, dentre outros. Essa exposição pode criar graves problemas de saúde, e por isso costuma-se utilizar protetores auditivos passivos