Instructions for the Preparation of Contributions to SPL 2006 Proceedings Gustavo Sutter 1 , Eduardo Boemo 1 , Elías Todorovich 2 , Sergio Lopez-Buedo 2 1 Escuela Politécnica Superior, Madrid, Spain, name.surname@ii.uam.es http://www.ii.uam. 2 Escuela Ingeniería Informática, Madrid, Spain, name.surname@ii.uam.es http://www.ii.uam.es Abstract. The abstract should summarize the contents of the paper and should contain at least 70 and at most 150 words. It should be set in 9-point font size and should be inset 1.0 cm from the right and left margins. There should be two blank (10-point) lines before and after the abstract. … 1 Introduction The preparation of manuscripts which are to be reproduced by photo-offset requires special care. Papers submitted in a technically unsuitable form will be returned for retyping, or canceled if the volume cannot otherwise be finished on time. 2 Manuscript Preparation You are strongly encouraged to use MS Word, please follow these instructions closely in order to make the volume look as uniform as possible. We would like to stress that the class/style files and the template should not be manipulated and that the guidelines regarding font sizes and format should be adhered to. This is to ensure that the end product is as homogeneous as possible. 2.1 Printing Area The printing area is 130 mm × 197 mm. The text should be justified to occupy the full line width, so that the right margin is not ragged, with words hyphenated as appropriate. Please fill pages so that the length of the text is no less than 180 mm.