Paper ID #23210 A Wearable Electrocardiograph as a Means to Combine Measurement and Makerspace Concepts in a Biomedical Instrumentation Course Sequence Dr. Steve Warren, Kansas State University Steve Warren received a B.S. and M.S. in Electrical Engineering from Kansas State University in 1989 and 1991, respectively, followed by a Ph.D. in Electrical Engineering from The University of Texas at Austin in 1994. Dr. Warren is a Professor in the Department of Electrical & Computer Engineering at Kansas State University. Prior to joining KSU in August 1999, Dr. Warren was a Principal Member of the Technical Staff at Sandia National Laboratories in Albuquerque, NM. He directs the KSU Medical Com- ponent Design Laboratory, a facility partially funded by the National Science Foundation that provides resources for the research and development of distributed medical monitoring technologies and learning tools that support biomedical contexts. His research focuses on (1) plug-and-play, point-of-care medi- cal monitoring systems that utilize interoperability standards, (2) wearable sensors and signal processing techniques for the determination of human and animal physiological status, and (3) educational tools and techniques that maximize learning and student interest. Dr. Warren is a member of the American Society for Engineering Education and the Institute of Electrical and Electronics Engineers. Mr. Charles Carlson, Kansas State University Mr. Charles Carlson is a Graduate Teaching and Research Assistant in Electrical and Computer Engineer- ing at Kansas State University, and he is currently pursuing his Ph.D. in Electrical Engineering. He works in the biomedical lab, and is a teaching assistant for ECE 241: Introduction to Computer Engineering. He is interested in engineering education, biotechnology, and bioinstrumentation. Mr. Andrew McKittrick, Kansas State University Mr. Andrew McKittrick is a Student and Undergraduate Researcher in Electrical and Computer Engi- neering at Kansas State University. He is currently pursuing a Degree in Computer Engineering and works in the biomedical lab with an emphasis in software development for instrumentation systems. He is interested in software engineering, data acquisition systems, and engineering education. Ms. Shangxian Wang Shangxian Wang is an undergraduate research assistant in the Kansas State University (KSU) Department of Electrical and Computer Engineering. She is pursuing her bachelor’s degree in Electrical Engineering and supports various efforts in the KSU Medical Component Design Laboratory. Shangxian is a student member of the IEEE Engineering in Medicine and Biology Society, and her interests include biomedical instrumentation, biomedical imaging, and K-12 STEM service projects. c American Society for Engineering Education, 2018