Transactions of the VŠB – Technical University of Ostrava, Mechanical Series No. 2, 2009, vol. LV, article No. 1689 Radim KLEČKA * , Jiří TŮMA ** , Miroslav MAHDAL ** * VIBRATION MEASUREMENT WITH PULSE AND DSPACE EQUIPMENT MĚŘENÍ VIBRACÍ SE SYSTÉMY PULSE A DSPACE Abstract This contribution describes techniques and results of measurement with TIRA vibration generator. A method of experimental modal analysis allows next restore of vibration data. The goal is check validity of head expanders and screw connection. This process is based to using ME’scope environment. Another goal is check possibilities of dSPACE platform to vibration measurement. This task includes design of connection between dSPACE system and power amplifier, creating of graphical user interface and analyzing main configuration parameters to improve quality of drive signal. Abstrakt Příspěvek se věnuje postupům a výsledkům měření, zahrnující vibrační generátor TIRA. Cílem je ověřit vliv rozšiřujících nástavců pro ukotvení testovaných struktur, při analýze vibrací pomocí definovaného budícího signálu. V případě rozměrově větší plošiny byla provedena experimentální modální analýza, včetně zpětné rekonstrukce pohybu v prostředí ME’scope. Druhým hlavním cílem je realizace ovládání vibrátoru prostřednictvím simulátoru dSPACE. Jedná se o vytvoření spojovací kabeláže, vhodného grafického rozhraní a analýzu hlavních konfiguračních parametrů pro dosažení požadované kvality budícího signálu. 1 INTRODUCTION Theoretical and also experimental test methods have been developed for many years. The theoretical technique of dynamic analysis uses finite element method (FEM). Real component or structure is required to experimental procedure. The experimental methods allow to check dynamic properties obtained by calculation in simulation software. Necessary condition is right excitation of the structure. The excitation is based to using impulse hammer or vibrator. The hummer is suitable for bigger and massive system [PAZDERA, MAZŮREK 2007]. 2 VIBRATION TEST EQUIPMENT There are several types of exciter principle: pneumatic, hydraulic, mechanical, electro- dynamic and piezoelectric. The electro-dynamic vibration generators are most commonly used. * Ing., Department of Control Systems and Instrumentation, Faculty of Mechanical Engineering, VSB - Technical University of Ostrava, 17. listopadu 15, 708 33 Ostrava-Poruba, tel. (+420) 597 324 227, e-mail radim.klecka@gmail.com ** prof. Ing. CSc., Department of Control Systems and Instrumentation, Faculty of Mechanical Engineering, VSB - Technical University of Ostrava, 17. listopadu 15, 708 33 Ostrava-Poruba, tel. (+420) 597 323 482, e- mail jiri.tuma@vsb.cz *** Ing., Department of Control Systems and Instrumentation, Faculty of Mechanical Engineering, VSB - Technical University of Ostrava, 17. listopadu 15, 708 33 Ostrava-Poruba, tel. (+420) 597 324 118, e-mail miroslav.mahdal@vsb.cz 55