The Journal of Engineering and Exact Sciences - JCEC ISSN: 2527-1075 Vol. 03 N. 08 (2017) 1200-1208 doi: 10.18540/jcecvl3iss8pp1200-1208 OPEN ACCESS ESTUDO DO COMPORTAMENTO ELETROQUÍMICO DE AMOSTRAS DE AÇO INOXIDÁVEL E DE TI (CP) COM DIFERENTES TIPOS DE REVESTIMENTO STUDY OF THE ELECTROCHEMICAL BEHAVIOUR OF STAINLESS STEEL AND TI (CP) SAMPLES WITH DIFFERENT TYPES OF COATING R. G. CALIXTO 1 , L. CALDEIRA 1 e J. C. M. da FONSECA 2 1 Instituto Federal do Sudeste de Minas Gerais – Campus Juiz de Fora, Departamento de Metalurgia, Brasil 2 Faculdade de Engenharia da Universidade do Porto, Departamento de Engenharia Metalúrgica e de Materiais, Portugal E-mail: r.gomescalixto@gmail.com article info Article history: Received 2017-09-04 Accepted 2017-11-20 Available online 2017-12-20 PALAVRAS-CHAVE: Biomateriais; Ensaios Eletroquímicos; Implantes Odontológicos; Osseointegração; Titânio. KEYWORDS: Biomaterials; Electrochemical Tests; Dental Implants; Osseointegration; Titanium . RESUMO: O Ti comercialmente puro (cp) tem sido utilizado extensivamente como biomaterial devido a suas características. Outro material amplamente empregado são os aços inoxidáveis, por apresentarem uma grande variedade e um custo acessível. O objetivo deste trabalho é estudar o comportamento eletroquímico de amostras de Ti e aço inoxidável 316 L através de ensaios eletroquímicos. Os ensaios utilizados para avaliar o desempenho das superfícies foram: Espectroscopia de Impedância Eletroquímica (EIE), Potencial de Circuito Aberto (OCP) e Voltametria Cíclica, realizados em solução de Ringer Lactato. Os resultados obtidos foram analisados a partir do software Gamry Analysis, observou-se que as amostras de aço inoxidável 316 L apresentaram resistência à corrosão inferior às de Ti, nas condições estudadas. Ficou demonstrado que o estado da superfície das amostras é um fator crítico já que dentre as amostras de Ti (cp) aquelas com revestimento apresentaram desempenho eletroquímico superior à usinada. ABSTRACT: The commercially pure Ti (cp) has been used extensively as biomaterial because of their characteristics. Another widely used material is stainless steels, because they are widely available and low cost. The objective of this work is study the electrochemical behavior of Ti samples and 316L stainless steel by electrochemical tests. The tests used to evaluate the performance of the surfaces were: Electrochemical Impedance Spectroscopy (EIS), Open Cycle Potential (OCP) and Cyclic Voltammetry, performed in Lactate Ringer's solution. The results obtained were analyzed from the Gamry Analysis software, it was observed that the 316 L stainless steel samples showed lower corrosion resistance than Ti, under the conditions studied. It was demonstrated that the state of the surface of the samples is a critical factor since among the samples of Ti (cp) those with coating presented best electrochemical performance than machined.